Photo Tripod Adapter for/fits Meade ETX 60/70/80/90/125 Telescopes
Converts single bolt tripod(1/4"-20 thread) to accept Meade ETX series dual bolt base using 3D printed parts.
Without a suitable adaptor readily available for my ETX60 grab-n-go telescope, I wanted something that looked nicer, and less expensive than what Meade has available. The bolts are included, and spare bolts, if lost, can be easily replaced from Lowe's. I created this for my own enjoyment, then, later, for a few friends who wanted one. It is constructed with an internal aluminum bar(for strength), surrounded by a 3D printed casing(exterior for aesthetics).
With EYEPIECE HOLDER AND CONTROLLER HOLDER ACCESSORY!!
ALUMINUM INTERNAL BAR SUPPORTED!!
Adaptor base, converts two bolt telescope to one bolt tripod. This is 3D PRINTED PLASTIC, surface imperfections is normal, it is fused layered plastic. Compatible with etx60 etx70 etx80 etx90 etx125. And most standard tripods(1/4"-20 thread) . Each piece takes about 20 hours print time, and a little more time to construct and packaged for immediate shipping! PLA material, ABS material, Aluminum parts all included. Minimal assembly, ready to use. Fits all etx bases with the two bolt holes, adapting it to one bolt hole tripod.
3D printed and hand assembled in Pennsylvania, USA. Constructed using PLA plastic and ABS plastic.
Warranty & Return Policy:
100% satisfaction or your money back guaranteed. No hassle returns for any reason.
US postal Service or UPS, always fast and well packaged.
Disclaimer: Seller/Item(s) shown, is not affiliated with Meade Instrument Corporation. Any trademarks mentioned in the description remain trademarks of its original owner. All accessories for sale here are represented as "made for", or "compatible with", in no way represented as manufactured by or made by the respective trademark owners.
Filed under: Eyepieces & Accessories