Bob's Knobs for Celestron C8 f/10 Secondary with EdgeHD Optics # C8edg
Description Ordering Info USA Shipping International Orders Returns Our eBay Store
1. PRODUCT DESCRIPTION
Collimate your Catadioptric or Newtonian reflector style telescopes without tools!
It's easy...just grab a Bob's Knob collimation thumbscrew and turn. You can even do it while looking through the eyepiece on most scopes. These thumbscrews are also much easier to use with gloves on. And perhaps most importantly, you'll never drop that pesky little Allen wrench or screwdriver into the grass again. Installation is a snap with the included instructions, and you can undo the modification at any time.
Fits: Celestron 8" (20 cm) f/10 SCT with Fastar secondary and EdgeHD optics.
Knobs: Black oxide steel, 12 mm (1/2") diameter
Threads: Black oxide steel
1. These knobs will fit only the Celestron 8" SCT with Fastar secondary and EdgeHD optics. These telescopes are marked "EDGEHD OPTICS" on the corrector ring. Do not use these knobs on the non-EdgeHD Fastar secondary; the screws on these knobs are too long. Be sure to check that the thread length on our knobs matches the thread length on the factory collimation screws.
2. The factory dust cover will fit normally with Bob's Knobs installed.
Note: Occasionally, the product you receive might have a slightly different cosmetic appearance or labeling than what is shown. This can often change from batch to batch according to the whims of the manufacturer. However, you will always receive a brand new, original product as described above.
Back to Top
Filed under: Eyepieces & Accessories